How to Set Up

1. Unboxing & Placing the Machine

• Remove the Walking Pad R2 Pro, power cable, remote control, safety key, wrist strap, hex wrench, silicone oil, and user manual from the packaging.
• Place the treadmill on a flat, stable surface with enough room around it for safe use.

2. Unfolding & Preparing

• Unfold the machine by lifting and extending the deck until it lays flat.
• Extend the handrails to a comfortable upright position and tighten the locking knobs.
• Install the safety key by plugging it into the designated slot — this enables the treadmill to start.
• Ensure the power cable is fully connected.

3. Power On

• Plug the treadmill into a power outlet and switch it on.
• The LED display will light up, showing metrics like time, speed, distance, steps, and calories.

Trouble Shooting

• Always make sure the safety key is installed before starting.
• Use the wrist strap attached to the remote — if pulled, it will immediately stop the treadmill.
• If the treadmill doesn’t respond, power cycle it: turn off → wait 10 seconds → turn on.
• If the remote control is not connected, follow the steps below:

How to re-connect the remote controller

In some cases, it appears that the remote controller is not connecting to the walking pad. In these cases, please perform a reconnection and follow the steps in the video or in the list below:

• Hold down the mode button on the remote controller and turn on the walking pad at the same time
• Wait until you hear a beep sound and release the mode button
• Press the mode button on the remote controller again to turn it back on

How to Return

1. Power Down

• Turn the treadmill off and unplug it from the outlet.
• Remove the safety key and keep it with the unit.

2. Clean & Repack

• Wipe the treadmill surface gently with a dry cloth.
• Avoid liquid cleaners or sprays.
• Repack all components in the original packaging:
• • Walking Pad R2 Pro
  • Power cable
  • Remote control
  • Safety key + wrist strap
  • Hex wrench + silicone oil
  • Manual / documentation

⚠️ Important Notes

If you notice:

• Unusual noises, squeaks, or belt dragging
• Belt slipping or rough movement
• Any operational irregularity

Please report this immediately to us before returning — this helps us:

• Diagnose issues (e.g., lubrication needed or belt tension adjustment)
• Arrange any necessary fixes
• Avoid unnecessary fees for unreported damages

Typically, noise or friction issues can be due to lack of belt lubrication, which can often be fixed with proper silicone oil application.

Updated on: 15/07/2026