> ## Knowledge Base Index
> Fetch the complete knowledge base index at: https://help.monis.rent/sitemap.xml
> Use this file to discover available pages before exploring further.
> Pure-Markdown content can be obtained by appending a '.md' suffix to the content URLs listed in the sitemap (without the trailing slash).

# Foldable Walking Pad R2 Pro setup guide

## How to Set Up

${frame}[](https://www.youtube.com/embed/RqqgBRll1VU)
### 1. Unboxing & Placing the Machine
* Remove the **Walking Pad R2 Pro**, **power cable**, **remote control**, **safety key**, **wrist strap**, **hex wrench**, **silicone oil**, and **user manual** from the packaging.
* Place the treadmill on a **flat, stable surface** with enough room around it for safe use.

### 2. Unfolding & Preparing
* **Unfold the machine** by lifting and extending the deck until it lays flat.
* Extend the **handrails** to a comfortable upright position and tighten the locking knobs.
* **Install the safety key** by plugging it into the designated slot — this enables the treadmill to start.
* Ensure the power cable is fully connected.

### 3. Power On
* Plug the treadmill into a power outlet and switch it on.
* The LED display will light up, showing metrics like **time, speed, distance, steps, and calories**.

## Trouble Shooting
* Always make sure the **safety key is installed** before starting.
* Use the **wrist strap** attached to the remote — if pulled, it will immediately stop the treadmill.
* If the treadmill doesn’t respond, power cycle it: **turn off → wait 10 seconds → turn on**.
* If the remote control is not connected, follow the steps below:

## How to re-connect the remote controller
In some cases, it appears that the remote controller is not connecting to the walking pad. In these cases, please perform a reconnection and follow the steps in the video or in the list below:
* Hold down the mode button on the remote controller and turn on the walking pad at the same time
* Wait until you hear a beep sound and release the mode button
* Press the mode button on the remote controller again to turn it back on

${frame}[](https://www.youtube.com/embed/Bwa5q8DRliQ)

# How to Return

### 1. Power Down
* Turn the treadmill **off** and unplug it from the outlet.
* Remove the **safety key** and keep it with the unit.

### 2. Clean & Repack
* Wipe the treadmill surface gently with a **dry cloth**.
* Avoid liquid cleaners or sprays.
* Repack **all components** in the **original packaging**:
    * Walking Pad R2 Pro
    * Power cable
    * Remote control
    * Safety key + wrist strap
    * Hex wrench + silicone oil
    * Manual / documentation

## ⚠️ Important Notes
If you notice:
* **Unusual noises**, squeaks, or belt dragging
* **Belt slipping or rough movement**
* Any **operational irregularity**

Please **report this immediately** to us before returning — this helps us:
* Diagnose issues (e.g., lubrication needed or belt tension adjustment)
* Arrange any necessary fixes
* Avoid unnecessary fees for unreported damages
Typically, noise or friction issues can be due to **lack of belt lubrication**, which can often be fixed with proper silicone oil application.